ZyXEL P-661H-D1 User Guide - Page 170
Configuring Static Route
View all ZyXEL P-661H-D1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 170 highlights
Chapter 8 Routing 8.2 Configuring Static Route Use this screen to view and configure IP static routes on the ZyXEL Device. Click Network Setting > Routing to open the following screen. Figure 65 Network Setting > Routing The following table describes the labels in this screen. Table 33 Network Setting > Routing LABEL DESCRIPTION Add New Static Route Click this to set up a new static route on the ZyXEL Device. # This is the number of an individual static route. Active This indicates whether the rule is active or not. A yellow bulb signifies that this static route is active. A gray bulb signifies that this static route is not active. Status This shows whether the static route is currently in use or not. A yellow bulb signifies that this static route is in use. A gray bulb signifies that this static route is not in use. Name This is the name that describes or identifies this route. Destination IP This parameter specifies the IP network address of the final destination. Routing is always based on network number. Gateway This is the IP address of the gateway. The gateway is a router or switch on the same network segment as the device's LAN or WAN port. The gateway helps forward packets to their destinations. Subnet Mask This parameter specifies the IP network subnet mask of the final destination. Interface This is the WAN interface through which the traffic is routed. Modify Click the Edit icon to go to the screen where you can set up a static route on the ZyXEL Device. Click the Delete icon to remove a static route from the ZyXEL Device. 170 P-661HNU-Fx User's Guide