ZyXEL P-661H-D1 User Guide - Page 93
Broadband Add/Edit: Routing- PPPoE continued, Broadband, P-661HNU-Fx User's Guide - default pass
View all ZyXEL P-661H-D1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Chapter 5 Broadband Table 6 Broadband Add/Edit: Routing- PPPoE (continued) Label DESCRIPTION PPP User Name Enter the user name exactly as your ISP assigned. If assigned a name in the form user@domain where domain identifies a service name, then enter both components exactly as given. PPP Password Enter the password associated with the user name above. PPPoE Service Name Type the name of your PPPoE service here. Authentication Method The ZyXEL Device supports PAP (Password Authentication Protocol) and CHAP (Challenge Handshake Authentication Protocol). CHAP is more secure than PAP; however, PAP is readily available on more platforms. Use the drop-down list box to select an authentication protocol for outgoing calls. Options are: AUTO: Your ZyXEL Device accepts either CHAP or PAP when requested by this remote node. PAP: Your ZyXEL Device accepts PAP only. CHAP: Your ZyXEL Device accepts CHAP only. Use Static IP Address IP Address PPPoE Passthrough MSCHAP: Your ZyXEL Device accepts MSCHAP only. MS-CHAP is the Microsoft version of the CHAP. A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is not fixed; the ISP assigns you a different one each time you connect to the Internet. Select this if you do not have a dynamic IP address. Enter the static IP address provided by your ISP. You will only see this field if you select Use Static IP Address In addition to the ZyXEL Device's built-in PPPoE client, you can enable PPPoE pass through to allow up to ten hosts on the LAN to use PPPoE client software on their computers to connect to the ISP via the ZyXEL Device. Each host can have a separate account and a public WAN IP address. PPPoE pass through is an alternative to NAT for application where NAT is not appropriate. Routing Feature NAT Enable IGMP Proxy Enable Disable PPPoE pass through if you do not need to allow hosts on the LAN to use PPPoE client software on their computers to connect to the ISP. Select this option to activate NAT on this connection. Internet Group Multicast Protocol (IGMP) is a network-layer protocol used to establish membership in a Multicast group - it is not used to carry user data. Apply as Default Gateway Select this option to have the ZyXEL Device act as an IGMP proxy on this connection. This allows the ZyXEL Device to get subscribing information and maintain a joined member list for each multicast group. It can reduce multicast traffic significantly. Select this option to have the ZyXEL Device use the WAN interface of this connection as the system default gateway. P-661HNU-Fx User's Guide 93