ZyXEL XGS4700-48F User Guide - Page 213

Chapter 21 Policy Rule Table 53 Advanced Application > Policy Rule (continued) LABEL Outgoing DESCRIPTION Select Send the packet to the mirror port to send the packet to the mirror port. Metering Out-of-profile action Select Send the packet to the egress port to send the packet to the egress port. Select Enable to activate bandwidth limitation on the traffic flow(s) then set the actions to be taken on out-of-profile packets. Select the action(s) to be performed for out-of-profile traffic. Select Drop the packet to discard the out-of-profile traffic. Select Change the DSCP value to replace the DSCP field with the value specified in the Out of profile DSCP field. Select Set Out-Drop Precedence to mark out-of-profile traffic and drop it when network is congested. Add Cancel Clear Select Do not drop the matching frame previously marked for dropping to queue the frames that are marked to be dropped. Click Add to insert the entry in the summary table below and save your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the non-volatile memory when you are done configuring. Click Cancel to begin configuring this screen afresh. Click Clear to set the above fields back to the factory defaults. 21.3 Viewing and Editing Policy Configuration To view a summary of the classifier configuration, scroll down to the summary table at the bottom of the Policy screen. To change the settings of a rule, click a number in the Index field. Figure 96 Advanced Application > Policy Rule: Summary Table XGS4700-48F User's Guide 213