ZyXEL XGS4700-48F User Guide - Page 281
Table 87
View all ZyXEL XGS4700-48F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 281 highlights
Chapter 26 IP Source Guard 26.7.1 ARP Inspection Port Configure Use this screen to specify whether ports are trusted or untrusted ports for ARP inspection. You can also specify the maximum rate at which the Switch receives ARP packets on each untrusted port. To open this screen, click Advanced Application > IP Source Guard > ARP Inspection > Configure > Port. Figure 132 ARP Inspection Port Configure The following table describes the labels in this screen. Table 87 ARP Inspection Port Configure LABEL Port Trusted State DESCRIPTION This field displays the port number. If you configure the * port, the settings are applied to all of the ports. Select whether this port is a trusted port (Trusted) or an untrusted port (Untrusted). The Switch does not discard ARP packets on trusted ports for any reason. The Switch discards ARP packets on untrusted ports in the following situations: Limit Rate (pps) • The sender's information in the ARP packet does not match any of the current bindings. • The rate at which ARP packets arrive is too high. You can specify the maximum rate at which ARP packets can arrive on untrusted ports. Rate and Burst Interval settings have no effect on trusted ports. Specify the maximum rate (1-2048 packets per second) at which the Switch receives ARP packets from each port. The Switch discards any additional ARP packets. Enter 0 to disable this limit. XGS4700-48F User's Guide 281