ZyXEL XGS4700-48F User Guide - Page 374

Chapter 41 VRRP 41.3.3 Configuring VRRP Parameters After you set up an IP interface, configure the VRRP parameters in the VRRP Configuration screen. Figure 199 IP Application > VRRP Configuration > VRRP Parameters The following table describes the labels in this screen. Table 136 IP Application > VRRP Configuration > VRRP Parameters LABEL Active Name Network Virtual Router ID DESCRIPTION Select this option to enable this VRRP entry. Enter a descriptive name (up to 32 printable ASCII characters) for identification purposes. Select an IP domain to which this VRRP entry applies. Select a virtual router number (1 to 7) for which this VRRP entry is created. Advertisement Interval Preempt Mode Priority You can configure up to seven virtual routers for one network. Specify the number of seconds between Hello message transmissions. The default is 1. Select this option to activate preempt mode. Enter a number (between 1 and 254) to set the priority level. The bigger the number, the higher the priority. Uplink Gateway This field is 100 by default. Enter the IP address of the uplink gateway in dotted decimal notation. Primary Virtual IP Secondary Virtual IP The Switch checks the link to the uplink gateway. Enter the IP address of the primary virtual router in dotted decimal notation. This field is optional. Enter the IP address of a secondary virtual router in dotted decimal notation. This field is ignored when you enter 0.0.0.0. 374 XGS4700-48F User's Guide