ZyXEL XGS4700-48F User Guide - Page 300
Table 94
View all ZyXEL XGS4700-48F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 300 highlights
Chapter 30 sFlow more than one collector if the traffic load to be monitored is more than one collector can manage. Figure 147 Advanced Application > sFlow > Collector The following table describes the labels in this screen. Table 94 Advanced Application > sFlow > Collector LABEL Collector Address DESCRIPTION Enter the IP address of the sFlow collector. UDP Port Enter a UDP port number the Switch uses to send sFlow datagram to the collector. If you change the port here, make sure you change it on the collector, too. The default port is 6343. Add Click Add to save your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the non- volatile memory when you are done configuring. Cancel Click Cancel to reset the fields to your previous configuration. Clear Click Clear to reset the fields to the factory defaults. Index This field displays the index number of this entry. Collector Address This field displays IP address of the sFlow collector. UDP Port This field displays port number the Switch uses to send sFlow datagram to the collector. Delete Check the rule(s) that you want to remove in the Delete column and then click the Delete button. Cancel Click Cancel to begin configuring this screen afresh. 300 XGS4700-48F User's Guide