ZyXEL XGS4700-48F User Guide - Page 235

Chapter 24 Multicast Table 64 Advanced Application > Multicast > Multicast Setting > IGMP Snooping VLAN (continued) LABEL DESCRIPTION Cancel Click Cancel to begin configuring this screen afresh. VLAN Use this section of the screen to add VLANs upon which the Switch is to perform IGMP snooping. Name Enter the descriptive name of the VLAN for identification purposes. VID Enter the ID of a static VLAN; the valid range is between 1 and 4094. Add Cancel Clear Index Name VID Delete Cancel Note: You cannot configure the same VLAN ID as in the MVR screen. Click Add to insert the entry in the summary table below and save your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the non-volatile memory when you are done configuring. Click Cancel to reset the fields to your previous configuration. Click Clear to reset the fields to the factory defaults. This is the number of the IGMP snooping VLAN entry in the table. This field displays the descriptive name for this VLAN group. This field displays the ID number of the VLAN group. Check the rule(s) that you want to remove in the Delete column, then click the Delete button. Click Cancel to clear the Delete check boxes. 24.5 IGMP Filtering Profile An IGMP filtering profile specifies a range of multicast groups that clients connected to the Switch are able to join. A profile contains a range of multicast IP addresses which you want clients to be able to join. Profiles are assigned to ports (in the Multicast Setting screen). Clients connected to those ports are then able to join the multicast groups specified in the profile. Each port can be assigned a single profile. A profile can be assigned to multiple ports. XGS4700-48F User's Guide 235