ZyXEL XGS4700-48F User Guide - Page 326

Chapter 35 RIP uses the route that has the lowest metric value. The following table lists the default administrative distance value of the route sources supported on the Switch. Table 110 Default Distance Value ROUTE SOURCE ADMINISTRATIVE DISTANCE Local 0 Static 1 OSPF 110 RIP 120 35.2 Configuring RIP Click IP Application > RIP in the navigation panel to display the screen as shown. You cannot manually configure a new entry. Each entry in the table is automatically created when you configure a new IP domain in the IP Setup screen (refer to Section 8.6 on page 113). Figure 161 IP Application > RIP The following table describes the labels in this screen. Table 111 IP Application > RIP LABEL Active Distance DESCRIPTION Select this check box to enable RIP on the Switch. Enter a number from 10 to 255 to specify the administrative distance that is assigned to routes learned by RIP. The lower the administrative distance value is, the more preferable the routing protocol is. See Section 35.1.1 on page 325 for more information about administrative distance. Index Note: You cannot set two routing protocols to have the same administrative distance. This field displays the index number of an IP interface. 326 XGS4700-48F User's Guide