ZyXEL XGS4700-48F User Guide - Page 448

Chapter 53 Configure Clone The following table describes the labels in this screen. Table 168 Management > Configure Clone LABEL Source/ Destination DESCRIPTION Enter the source port under the Source label. This port's attributes are copied. Port Enter the destination port or ports under the Destination label. These are the ports which are going to have the same attributes as the source port. You can enter individual ports separated by a comma or a range of ports by using a dash. Example: Basic Setting Advanced Application Apply Cancel • 2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports. • 2-6 indicates that ports 2 through 6 are the destination ports. Select which port settings (configured in the Basic Setting menus) should be copied to the destination port(s). Select which port settings (configured in the Advanced Application menus) should be copied to the destination ports. Click Apply to save your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the nonvolatile memory when you are done configuring. Click Cancel to begin configuring this screen afresh. 448 XGS4700-48F User's Guide