ZyXEL ZyWALL USG 2000 User Guide - Page 357

Chapter 15 Policy and Static Routes Table 82 Configuration > Network > Routing > Policy Route > Edit (continued) LABEL DESCRIPTION Maximum Bandwidth Specify the maximum bandwidth (from 1 to 1048576) allowed for the route in kbps. If you enter 0 here, there is no bandwidth limitation for the route. If the sum of the bandwidths for routes using the same next hop is higher than the actual transmission speed, lower priority traffic may not be sent if higher priority traffic uses all of the actual bandwidth. Bandwidth Priority To reserve bandwidth for traffic that does not match any of the policy routes, leave some of the interface's bandwidth unbudgeted and do not enable Maximize Bandwidth Usage. Enter a number between 1 and 7 to set the priority for traffic. The smaller the number, the higher the priority. If you set the maximum bandwidth to 0, the bandwidth priority will be changed to 0 after you click OK. That means the route has the highest priority and will get all the bandwidth it needs up to the maximum available. A route with higher priority is given bandwidth before a route with lower priority. Maximize Bandwidth Usage OK Cancel If you set routes to have the same priority, then bandwidth is divided equally amongst those routes. Select this check box to have the ZyWALL divide up all of the interface's unallocated and/or unused bandwidth among the policy routes that require bandwidth. Do not select this if you want to reserve bandwidth for traffic that does not match any of the policy routes. Click OK to save your changes back to the ZyWALL. Click Cancel to exit this screen without saving. 15.3 IP Static Route Screen Click Configuration > Network > Routing > Static Route to open the Static Route screen. This screen displays the configured static routes. Configure static routes to be able to use RIP or OSPF to propagate the routing information to other routers. Figure 275 Configuration > Network > Routing > Static Route ZyWALL USG 2000 User's Guide 357