ZyXEL ZyWALL USG 2000 User Guide - Page 926
IKE Logs continued
View all ZyXEL ZyWALL USG 2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 926 highlights
Appendix A Log Descriptions Table 272 IKE Logs (continued) LOG MESSAGE DESCRIPTION [SA] : Tunnel [%s] Phase 1 invalid protocol %s is the tunnel name. When negotiating Phase-1, the packet was not a ISKAMP packet in the protocol field. [SA] : Tunnel [%s] Phase 1 invalid transform %s is the tunnel name. When negotiating Phase-1, the transform ID was invalid. [SA] : Tunnel [%s] Phase 1 key group mismatch %s is the tunnel name. When negotiating Phase-1, the DH group of the attribute list `attrs' did not match the security policy. [SA] : Tunnel [%s] Phase 1 negotiation mode mismatch %s is the tunnel name. When negotiating Phase-1, the negotiation mode did not match. [SA] : Tunnel [%s] %s is the tunnel name. When negotiating Phase-2, the Phase 2 authentication authentication algorithm did not match. algorithm mismatch [SA] : Tunnel [%s] Phase 2 encapsulation mismatch %s is the tunnel name. When negotiating Phase-2, the encapsulation did not match. [SA] : Tunnel [%s] Phase 2 encryption algorithm mismatch %s is the tunnel name. When negotiating Phase-2, the encryption algorithm did not match. [SA] : Tunnel [%s] Phase 2 pfs mismatch %s is the tunnel name. When negotiating Phase-2, the PFS specified did not match. [SA] : Tunnel [%s] Phase 2 pfs unsupported: %d %s is the tunnel name. When negotiating Phase-2, this device does not support the PFS specified. [SA] : Tunnel [%s] Phase 2 SA encapsulation mismatch %s is the tunnel name. When negotiating Phase-2, the SA encapsulation did not match. [SA] : Tunnel [%s] Phase 2 SA protocol mismatch %s is the tunnel name. When negotiating Phase-2, the SA protocol did not match. [SA] : Tunnel [%s] SA %s is the tunnel name. When negotiating Phase-2, the SA sequence size mismatch sequence size did not match. [XCHG] exchange type is not IP, AGGR, or INFO This device is the responder and this is the initiator's first packet, but exchange type is not IP, AGGR, or INFO and the packet is ignored. Cannot resolve My IP Addr %s for Tunnel [%s] 1st %s is my ip address. 2nd %s is the tunnel name. When selecting a matched proposal in phase-1, the engine could not get My-IP address. Cannot resolve Secure Gateway Addr %s for Tunnel [%s] 1st %s is my ip address. 2nd %s is the tunnel name; When selecting a matched proposal in phase-1, the engine could not get the correct secure gateway address. Could not dial dynamic %s is the tunnel name. The tunnel is a dynamic tunnel and tunnel "%s" the device cannot dial it. Could not dial %s is the tunnel name. The tunnel setting is not complete. incomplete tunnel "%s" 926 ZyWALL USG 2000 User's Guide