ZyXEL ZyWALL USG 2000 User Guide - Page 477

Chapter 25 IPSec VPN These modes are illustrated below. Figure 341 VPN: Transport and Tunnel Mode Encapsulation Original Packet IP Header TCP Header Data Transport Mode Packet IP Header AH/ESP Header TCP Header Data Tunnel Mode Packet IP Header AH/ESP Header IP Header TCP Header Data In tunnel mode, the ZyWALL uses the active protocol to encapsulate the entire IP packet. As a result, there are two IP headers: • Outside header: The outside IP header contains the IP address of the ZyWALL or remote IPSec router, whichever is the destination. • Inside header: The inside IP header contains the IP address of the computer behind the ZyWALL or remote IPSec router. The header for the active protocol (AH or ESP) appears between the IP headers. In transport mode, the encapsulation depends on the active protocol. With AH, the ZyWALL includes part of the original IP header when it encapsulates the packet. With ESP, however, the ZyWALL does not include the IP header when it encapsulates the packet, so it is not possible to verify the integrity of the source IP address. IPSec SA Proposal and Perfect Forward Secrecy An IPSec SA proposal is similar to an IKE SA proposal (see IKE SA Proposal on page 470), except that you also have the choice whether or not the ZyWALL and remote IPSec router perform a new DH key exchange every time an IPSec SA is established. This is called Perfect Forward Secrecy (PFS). If you enable PFS, the ZyWALL and remote IPSec router perform a DH key exchange every time an IPSec SA is established, changing the root key from which encryption keys are generated. As a result, if one encryption key is compromised, other encryption keys remain secure. If you do not enable PFS, the ZyWALL and remote IPSec router use the same root key that was generated when the IKE SA was established to generate encryption keys. The DH key exchange is time-consuming and may be unnecessary for data that does not require such security. ZyWALL USG 2000 User's Guide 477