2006 Subaru B9 Tribeca Owner's Manual - Page 147

Instruments and controls 3-27 the high beam indicator light " " on the instrument panel also comes on. Turn signal lever Illumination brightness control Daytime running light system The tail lights, parking lights, and side marker lights are not turned on by the daytime running light system. The light switch must always be turned to the " " position when it is dark outside. The low beam headlights will automatically come on at reduced brightness when the engine has started, under the following conditions: The parking brake is fully released. The light switch is in the "OFF" or " " position. 300509 300510 To activate the right turn signal, push the turn signal lever up. To activate the left turn signal, push the turn signal lever down. When the turn is finished, the lever will return automatically. If the lever does not return after cornering, return the lever to the neutral position by hand. To signal a lane change, push the turn signal lever up or down slightly and hold it during the lane change. The turn signal indicator lights will flash in the direction of the turn or lane change. The lever will return automatically to the neutral position when you release it. When the light switch is in the "OFF" position, you can adjust the brightness of the instrument panel illumination for better visibility. The brightness of audio, air conditioner, multi-function display (if equipped) and instrument panel illumination automatically dims when the light switch is in the " " or " " positions. You can adjust brightness of the illumination for better visibility. To brighten, turn the control dial upward. To darken, turn the control dial downward. NOTE When the control dial is turned fully up- CONTINUED -