2006 Subaru B9 Tribeca Owner's Manual - Page 53

Seat, seatbelt and SRS airbags 1-29 Continuous illumination of the warning light Illumination of the warning light while driving System servicing When discarding a seatbelt retractor assembly or scrapping the entire vehicle damaged by a collision, consult your SUBARU dealer. Tampering with or disconnecting the system's wiring could result in accidental activation of the seatbelt pretensioner and/or airbag or could make the system inoperative, which may result in serious injury. The wiring harnesses of the seatbelt pretensioner and SRS airbag systems are covered with yellow insulation and the connectors of the system are yellow for easy identification. Do not use electrical test equipment on any circuit related to the seatbelt pretensioner and airbag systems. For required servicing of the seatbelt pretensioner, see your nearest SUBARU dealer. NOTE If the front part of the vehicle is damaged in an accident to the extent that the seatbelt pretensioner does not operate, contact your SUBARU dealer as soon as possible. Precautions against vehicle modification Always consult your SUBARU dealer if you want to install any accessory parts to your vehicle. The front sub sensors are located in both front fenders and the airbag control module including the impact sensors is located under the center console. If you need service or repair in those areas or near the front seatbelt retractors, we recommend that you have an authorized SUBARU dealer perform the work. Do not perform any of the following modifications. Such modifications can interfere with proper operation of the seatbelt pertensioners. Attachment of any equipment (bush bar, winches, snow plow, skid plate, etc.) other than genuine SUBARU accessory parts to the front end. Modification of the suspension system or front end structure. - CONTINUED -