2006 Subaru B9 Tribeca Owner's Manual - Page 64

1-40 Seat, seatbelt and SRS airbags the seatback. Each lower anchorage is located where the seat cushion meets the seatback. 2. Make the clearance between the seat cushion and seatback a little wider to locate the two anchorages (bars) for the position where you want to install the child restraint system. When you install a child restraint system, follow the manufacturer's instructions supplied with it. After installing the child restraint system, check to ensure that it is held securely in position. If it is not held tight and secure, the danger of your child suffering personal injury in the event of an accident may be increased. 0 100521 100520 3. While following the instructions supplied by the child restraint system manufacturer, connect the lower hooks onto the lower anchorages located at " " marks on the bottom of the seatback. When the hooks are connected, make sure the adjacent seatbelts are not caught. 4. [If your child restraint system is of a flexible attachment type (which uses tether belts to connect the child restraint system properly to the lower anchorages)] While pushing the child restraint into the seat cushion, pull both left and right lower tether belts up to secure the child restraint system firmly by taking up the slack in the belt. 5. Connect the top tether hook to the tether anchorage and firmly tighten the tether. For information on how to set the top tether, read the following "Top tether anchorages". 100519 1. Slide the seat or seat pair to its rearmost position.