2006 Subaru Forester Owner's Manual - Page 101

2-10 Keys and doors Programming transmitter codes into system: To register a new transmitter with the keyless entry system, it is necessary to program the transmitter's code (identification number) into the system. A label showing the code is affixed to the bag containing the transmitter, and another is affixed to the circuit board inside the transmitter. If there is no bag, open the transmitter case and make a note of the eight-digit number. Program the number into the system in accordance with the following procedure: 1. Firmly close the doors and the rear gate. 2. Open the driver's door, sit on the driver's seat, and close the door. 3. Perform the following steps within 45 seconds. 2 1 200814 200718 1) ON 2) LOCK Bag containing transmitter 2) Insert the key into the ignition switch, then turn it from the "LOCK" position to the "ON" position 10 times within 15 seconds. NOTE When you complete step 2), an electronic tone will sound once. If you do not perform steps 1) and 2) within 45 seconds, an error will occur. An electronic tone will not sound. In this event, perform the whole procedure again beginning with part 1. 200719 200813 Transmitter circuit board 1) Open and close the driver's door once. 4. Open and close the door once within 15 seconds.