Brother International BAS-705 Instruction Manual - English - Page 16
-2.Data setting methods, BAS-705
View all Brother International BAS-705 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
3-2.Data setting methods PROGRAM mode 3-2-1.Setting the belt loop feeding-out length ɾ This sets the length of belt loop material to be fed out before it is cut. ɾ The length can be set to between 50 - 120 mm. 3. PANEL OPERATION #"4 WARNING POWER Ϧηοτ RESET Ϟʔυ MODE બ SELECT औΓফ͠ CANCEL r w ֬ ఆ ENTER PROGRAM MODE ˗ 2nd bobbin counter Speed Loop length PROGRAM MODE 2nd bobbin counter Speed ˗ Loop length PROGRAM MODE 2nd bobbin counter Speed ˗ Loop length PROGRAM MODE 2nd bobbin counter Speed ˗ Loop length e z// zzb ˛ t 1. Press the MODE switch w to select PROGRAM mode. 2. Use the ˛ and ˝SELECT switches e to move the pointer " ˗ " so that "Loop length" is selected. 3. While using the SELECT switch eto move the cursor "-", press the˛ and ˝ SELECT switches e to set the desired belt loop length. * If the CANCEL switch r is pressed, the setting will remain at the previous length setting. 4. Press the ENTER switch t to accept the new length setting. The cursor "-" will then disappear. ʕ 13 ʕ B A S -705