Brother International BAS-705 Instruction Manual - English - Page 23

3. PANEL OPERATION 3-2-7. Setting the X scale and Y scale ɾ This procedure is used to set the enlargement and reduction ratios for the sewing pattern in the X direction and Y direction. ɾ The setting ranges for both the X scale and Y scale are between 45% - 150%. However,because the size of the pattern will be checked against the sewing area, it may not be possible to set the scale to the maximum setting in this range. #"4 WARNING POWER Ϧηοτ RESET Ϟʔυ MODE બ୒ SELECT औΓফ͠ CANCEL r w ֬ ఆ ENTER AUTO MODE ˗ 2nd bobbin counter Speed Loop length ADJUSTMENT(/) Loop/feed ˗ X-Y/program X-Y/test feed X-Y/PROGRAM/(ADJ) Program No. ˗ X scale (%) Y scale (%) X-Y/PROGRAM/(ADJ) Program No. ˗ X scale (%) Y scale (%) X-Y/PROGRAM/(ADJ) Program No. ˗ X scale (%) Y scale (%) e z// zz/ ˛ t 1. Press the MODE switch w to select AUTO mode. 2. While pressing the SELECT switch e, press the MODE switch w. * This will change the mode to ADJUSTMENT mode. 3. Use the
˛
and ˝
SELECT switches e to move the pointer "˗" so that "X-Y/program" is selected, and then press the ENTER switch t. 4. Use the ˛ and ˝ SELECT switches e again to move the pointer "˗" so that "X scale" or "Y scale" is selected. 5. While using the SELECT switch eto move the cursor "-" , press the ˛ and˝SELECT switches e to set the scale setting. * If the CANCEL switch r is pressed, the old previously-set scale ratio will appear again on the display. 6. Press the ENTER switch t. * The new scale ratio setting for the X scale or Y scale will appear on the display. * At this time, the feed mechanism will return to the sewing home position. ˛ ʕ 20 ʕ B A S -705