Brother International BE-1201B-AC Instruction Manual - English - Page 227
Thread Wiper Adjustment - acpc
View all Brother International BE-1201B-AC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 227 highlights
5. Thread Wiper Adjustment Chapter 10 Adjustment ! BE-1201B-AC-PC [10] [7] [8] Align [1] [3] [4] [7] [6] [5] [2] W1632 [9] [8] Needle [6] W1633 1. Move solenoid arm [1] in the direction of the arrow with your finger. Loosen three bolts [3] and adjust thread hook [2] for smooth movements. 2. If there is a difference in motion between needle bars No. 1 and No. 9 (No. 12 for BE-1201B-ACPC), loosen four screws [4] and make an adjustment by moving thread presser base [5] in the direction of the arrow. Make sure that no interference will occur when pressure foot [6] is raised by the solenoid. 3. Move finger guard plate [7] up and down, and align the top of finger guard [8] with the tips of the needles. 4. After the above steps are complete, check thread hook [2] for smooth movements. If the thread hook does not move smoothly, apply grease (Grease Tank BR2 (black)) to the gray part of thread guide solenoid base [10] and check its movements. Note) • Care should be taken if the finger guard is inclined. If the finger guard in such a state is pushed exces-sively toward the needle at the time of color change, it may interfere with the presser foot. • Then make an adjustment in the crosswise direction by sliding bolt [9] of finger guard [8] BE-0901E-AC-PC• BE-1201B-AC-PC 10-9