Brother International BE-1201B-AC Instruction Manual - English - Page 243
Pass a thread through thread guide [3].
View all Brother International BE-1201B-AC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 243 highlights
! Winding lower thread [5] [8] [3] Chapter 13 Connection and Installation of Optional Equipment [7] [6] [4] [9] [1] [2] W1638 1. Turn on the power switch. 2. Fit bobbin [1] to the bobbin winder shaft [2]. 3. Pass a thread through thread guide [3]. 4. Wind the thread around bobbin [1] several times in the direction of the arrow. 5. Press bobbin hold [4]. Note) • If the thread cannot be wound evenly, loosen screw [5] and move thread guide [3] from side to side for adjustment. • To wind more thread around the bobbin, loosen screw [5] and shift bobbin hold [4]. 6. After winding is finished, remove the bobbin from the bobbin winder shaft and trim the thread using tread trimmer [7]. Note) • If the thread passed though thread guide [3] comes off, loosen knob [8]. If the thread is wound loosely, tighten knob [8]. • If circuit protector [9] is activated, the bobbin winder motor does not rotate. Wait for a while until the motor cools and press the circuit protector. (If the motor is still hot, the pressed circuit protector will come out.) BE-0901E-AC-PC• BE-1201B-AC-PC 13-3