Brother International BE-1201B-AC Instruction Manual - English - Page 55
Canceling errors, Pressing other switches can stop alarm sound.
View all Brother International BE-1201B-AC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Chapter 3 Embroidering Procedures Checks the embroidering area. Exits from embroidering mode. Press this switch while holding down switch simultaneously to stop embroidering. Moves the hoop automatically into the embroidering area when the embroidery position is out of the area. When this switch is pressed while the computer has given a command to move embroidery hoop ("HOOP" appears on the panel), the embroidery hoop moves designated position. Moves the hoop to software-set position. When this switch is pressed again, the hoop returns to the previous position. Clear inching when this switch is pressed in the inching mode. Moves the needle bar. The needle moves by the diameter every time this switch is pressed. Moves the hoop. Step-back or forward is available during suspension. (Use switches only.) Changes the speed range during embroidering (Use switches only). Sets machine to the inching mode when is pressed while holding down during suspension. Carries out inching of the hoop when the switch is pressed in the inching mode. ( panel) appears on the W1668 Selects the flat or cap hoop. This selection should be done before turning the power ON to the machine. The setting will not be changed if the selection is done after turning the power OFF. ! Canceling errors When an error message appears, it is canceled by pressing Pressing other switches can stop alarm sound. switch. When thread breakage or wiper out error has occurred, step-back or forward switch can be used to cancel errors. B BE-0901E-AC-PC• BE-1201B-AC-PC 3-3