Brother International BE-1201B-AC Instruction Manual - English - Page 40
Preparation for Embroidering, 3-1 Upper Threading
View all Brother International BE-1201B-AC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Chapter 2 Preparation of Embroidery Machine 3. Preparation for Embroidering CAUTION Turn off the power switch before starting preparation. Failure to do so may start the machine unintentionally through an accidental activation of the START switch, resulting in bodily injuries. 3-1 Upper Threading ! BE-0901E-AC-PC [1] Thread guide tension disc [2] Thread breakage pulley [3] Upper thread guide (upper) [4] Upper thread guide (middle) [5] Thread guide (upper) Spring [6] Thread guide A [7] Lower thread guide [8] Needle bar thread guide Inner thread guide [7] Lower thread guide W1572 W1573 1. Pass an upper thread from the cotton stand through the holes of the thread guide right above each cotton stand bar. When passing the thread, pass it through the first hole from the lower side, lead it around the thread guide, and then pass it through the second hole also from the lower side. 2. Push up the thread guide tension disc with your finger, and pass it from the left to the lower hole. Wind the thread clockwise twice around thread breakage pulley [2]. 3. Pass the thread through the hole of upper thread guide(upper) [3]. Wind the thread clockwise once around the rotary tension disc and place it on the spring. 4. Pass the thread through each hole of upper thread guide(middle) [4] and thread guide(upper) [5]. 5. After passing the thread through the hole of thread guide(upper) [5], insert the thread into the right side of the inner thread guide and pass it through the hole of the thread take-up. 6. Bring the thread back to the inner thread guide. Insert the thread into the hole from the upper section into thread guide A [6] and lower thread guide [7]. 7. Pass the thread through the hole of the needle bar thread guide [8] and pass it through the needle eye. Do not pass it through the presser foot. Pass it to needle bar thread guide at the front of lower thread guide [7]. 2-12 BE-0901E-AC-PC• BE-1201B-AC-PC