Brother International BE-1201B-AC Instruction Manual - English - Page 44
Preparation of Machine for Operation, Check the following before turning on the power
View all Brother International BE-1201B-AC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Chapter 2 Preparation of Embroidery Machine 3-4 Preparation of Machine for Operation ! Check the following before turning on the power Thread Embroidery hoop Needle stop position (1) Are upper thread settings complete? (2) Are threads passed smoothly? (3) Are threads passed through needles? (4) Are lower thread settings complete? (1) Is there any looseness in the material? (2) Is the hoop clamped securely? (1) Are thread take-ups aligned horizontally? (2) Are needle bars positioned at the top? Note) If thread take-up [1], which is not in the drive position, is out of alignment, raise it by hand. The stopper works to align thread take-up [1] with the others. [1] (This figure shows model BE-0901E-AC.) BE-1584 Turning on the power switch brings up the message "Moving frame" and sounds a beep as a warning. Then, the X and Y carriages move the embroidery hoop to the home position or the position where it was located at the end of the previous operation. Check that there is no obstacle above the hoop which will interfere with needles or presser feet. 2-16 BE-0901E-AC-PC• BE-1201B-AC-PC