Brother International BE-1201B-AC Instruction Manual - English - Page 45

Chapter 2 Preparation of Embroidery Machine ! When the machine is turned on: "E-07" may appear on the operation panel while a buzzer sounds intermittently. In such a case, the machine is not ready to start because the needle bar case is not positioned correctly, and thus the needles are not in proper alignment with the holes of the needle plates. Follow the steps below to fix this. [2] 1. Check if the needles stop in the normal position. When cam plate [2] is raised, it is in the automatic jump position. This is the normal position. ! BE-0901E-AC-PC [3] ! BE-1201B-AC-PC [3] W1585 W1586 2. Turn knob [3] slowly. If knob [3] cannot be turned or is too heavy to rotate, thread take-up [1] or the needle bar is not in the normal position. Check if any obstacle interferes with the needle end or the presser foot. Note) Do not turn the knob forcibly. 3. There is a dead zone in which the needle bar case cannot be moved even by turning knob [3]. Turn the knob to the normal position in the vicinity of the center of the dead zone. 4. Press STOP . 5. A buzzer sounds and the X and Y carriages move automatically so as to bringthe hoop center to the home position or to the position where it was located at the end of the previous operation. W1587 BE-0901E-AC-PC• BE-1201B-AC-PC 2-17