Canon PC980 Service Manual - Page 277
e-2. Routing the Scanner Drive Cable, Before Starting the Work
UPC - 030275182323
View all Canon PC980 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 277 highlights
CHAPTER 11 TROUBLESHOOTING e-2. Routing the Scanner Drive Cable 1. Before Starting the Work Prepare the following: • Mirror positioning tool (FY9-3009) • Cable clip (FY9-3017) • Adhesive tape 1) Set the mirror positioning tool as shown. Figure 11-213 2) Prepare about five strips of adhesive tape (each one about 20 × 50 mm). 3) Remove the copyboard glass. (See Chapter 7.III.C.1."Removing the Copyboard Glass.") 4) Disconnect the connectors (J101, J131) [1] from the DC controller PCB. 11-12 [1] Figure 11-214 COPYRIGHT © 1999 CANON INC. CANON PC800s/900s REV.0 AUG. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 11
TROUBLESHOOTING
COPYRIGHT
©
1999
CANON INC.
CANON
PC800s/900s REV.0 AUG.1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
11-12
e-2. Routing the Scanner Drive Cable
1.
Before Starting the Work
Prepare the following:
• Mirror positioning tool (FY9-3009)
• Cable clip (FY9-3017)
• Adhesive tape
1)
Set the mirror positioning tool as shown.
Figure 11-213
2)
Prepare about five strips of adhesive tape (each one about 20
×
50 mm).
3)
Remove the copyboard glass. (See Chapter 7.III.C.1.“Removing the Copyboard Glass.”)
4)
Disconnect the connectors (J101, J131) [1] from the DC controller PCB.
Figure 11-214
[1]