Canon iPF710 iPF710 User Manual - Page 625

Problems with the printing quality The edges of the paper are dirty Cause Corrective Action The Platen has become dirty after borderless printing Open the Top Cover and clean the Platen. or printing on small paper. (→P.589) The paper type as specied on the printer does not match the type specied in the printer driver. Make sure the same paper type is specied on the printer as in the printer driver. (→P.105) (→P.134) Make sure the same paper type is specied in the printer driver as on the printer. 1.Hold down the Stop button for a second or more to cancel printing. 2.Change the paper type in the printer driver and try printing again. The paper is wrinkled or warped. Straighten out the wrinkles or curls and reload the paper. Do not use paper that has been printed on previously. (→P.110) (→P.135) A cut line is printed because the function to reduce cutting dust has been activated. If this function is not needed, deactivate CutDustReduct. through the printer menu. (→P.48) The Printhead is set too low. In Head Height, choose Automatic. (→P.548) You are printing on heavyweight paper or paper that curls or wrinkles easily after absorbing ink. When printing on Heavyweight Coated Paper or other paper-based media, choose a VacuumStrngth setting of Strong or Strongest. If paper still rubs against the printhead, try raising the Printhead by setting Head Height to Highest. (→P.557) (→P.548) When printing on CAD Tracing Paper or lm-based media, choose a VacuumStrngth setting of Standard, Strong, or Strongest. If paper still rubs against the printhead, try raising the Printhead by setting Head Height to Highest. (→P.557) (→P.548) The Ejection Guide is soiled. Clean the Ejection Guide. (→P.588) The surface of the paper is dirty Cause The Paper Retainer is soiled. Corrective Action Clean the Paper Retainer. (→P.591) You are using a paper that does not dry easily. Specify a time of about a minute in Roll DryingTime. Troubleshooting 611