Canon iPF710 iPF710 User Manual - Page 64

Control Panel Paper Details Setting Item (The paper type is displayed here.)(*1) Roll DryingTime Scan Wait Time Feed Priority Adjust Length Head Height Skew Check Lv. VacuumStrngth Width Detection NearEnd RollMrgn Cut Speed Trim Edge First Description, Instructions Specify the time to wait for the ink to dry for each sheet. Specify the time to wait for the ink to dry between each scan in bidirectional printing, in consideration of how quickly the ink dries. Note that printing will take longer if you specify a wait time. Specify exact paper feeding, if desired. Normally, select Automatic. Choose Print Length if you prefer to feed the paper an exact amount. However, note that choosing Print Length may result in slight banding in the direction of Carriage scanning. Displayed if Feed Priority is Print Length. Adjustment relative to the amount of stretching or shrinkage of the current paper. Enter either the adjustment results from Print Pattern or the discrepancy that you measured (as a percentage). For paper that tends to stretch, increase the feed amount by choosing a higher adjustment value. For paper that tends to shrink, decrease the feed amount by choosing a lower adjustment value. Adjust the Printhead height. (→P.548) If you print on Japanese paper (washi) or other handmade paper that has an irregular width, choose Loose for a higher skew detection threshold, or choose Off to disable skew detection. However, if paper is loaded askew when detection is Off, note that paper jams or Platen soiling may occur. Specify the level of suction that holds paper against the Platen. (→P.557) Specify this option to print inside boundaries, for example, when printing at a different size than the paper size. Paper width and skew are not detected if you select Off. If paper is loaded askew, note that paper jams or Platen soiling may occur. Specify the minimum margin at the leading edge of roll paper to ensure better printing quality at the leading edge. Note that if you choose 3mm, it may lower the printing quality at the leading edge and affect feeding accuracy. The printed surface may be scratched, and ink may adhere to the leading edge. It may also cause the Platen to become soiled. Choose the cutting speed. If you use adhesive paper, choosing Slow helps prevent adhesive from sticking to the cutter and keeps the cutter sharp. If a roll is loaded, the end of the paper will be cut. 50 Printer Parts