Cisco 7206VXR Installation Guide - Page 129

Chapter 6 Troubleshooting the Installation Troubleshooting the Power Subsystem - The RJ-45 LINK LED comes on only when the Fast Ethernet's RJ-45 port is receiving a carrier signal from the network. This LED remains off during normal operation of the router unless there is an incoming carrier signal, and does not indicate startup problems. If this LED remains off when starting the router, it is probably a problem with the Fast Ethernet port on the I/O controller. Proceed to the "Troubleshooting the I/O Controller" section on page 6-6. Note An MII LINK LED is not provided on the I/O controller because the LED is provided on external transceivers that are required for connecting to the MII port on the I/O controller. Refer to Chapter 3, "Installing the Cisco 7206," the "Fast Ethernet Connection Equipment" section on page 3-16 for Fast Ethernet MII connection requirements. - The SLOT 1 and SLOT 2 LEDs only come on when either PC Card slot is being accessed by the system. These LEDs remain off during normal operation of the router and do not indicate startup problems. • The enabled LED on each port and service adapter comes on when the network processing engine completes its initialization of the adapter for operation. The enabled LED indicates that the adapter is receiving power and has been recognized by the network processing engine; it does not indicate the state of the individual interfaces on the port adapters (service adapters do not have interfaces). If an enabled LED fails to come on, proceed to the "Troubleshooting the Port Adapter and Service Adapters" section on page 6-7. • When all LEDs come on to indicate that the system has booted successfully, the initial system banner should be displayed on the console screen. If it is not displayed, refer to the "Console and Auxiliary Port Connection Equipment" section on page 3-14 in Chapter 3, "Installing the Cisco 7206" to verify that the terminal is set correctly and that it is properly connected to the I/O controller's console port. Troubleshooting the Power Subsystem Check the following to help isolate a problem with the power subsystem: • On the first power supply, is the power OK LED on? - If yes, the power source is good, and the power supply is functional. - If no, make sure the AC power cable is connected at both ends. - If no, make sure the circuit breaker controlling the DC power supply leads in the ON position. - If no, make sure the - V, +V, and ground leads are properly connected to the router. - If the power OK LED remains off, and the power switch is set correctly, suspect the power source or the power cable. Turn the switch off, connect the power cable to another power source, if available, and turn the switch back on. If the LED comes on, the problem is the first power source. - If the power OK LED fails to come on after you connect the power supply to a new power source, replace the power cord, and turn the switch back on. If the AC power (or input power) LED then comes on, return the first power cable for replacement. - If the LED still fails to come on when the power supply is connected to a different power source with a new power cable, the power supply is probably faulty. If a second power supply is available, install it in the other power supply bay and contact a service representative for further instructions. OL-5102-02 Cisco 7206 Installation and Configuration Guide 6-5