Cisco 7206VXR Installation Guide - Page 72
Rack-Mounting the Chassis in a Telco-Type Rack with Installed Cable-Management
UPC - 746320975061
View all Cisco 7206VXR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Rack-Mounting the Cisco 7206 Chapter 3 Installing the Cisco 7206 If you plan to install the cable-management brackets on a Cisco 7206 that you are rack-mounting, you must install the cable-management brackets and the rack-mount brackets on the chassis before you install the chassis in the rack. There are two cable-management bracket configurations when you rack-mount the Cisco 7206 from the front. In the first configuration, the cable-management brackets are installed over the rack-mount brackets, and four screws secure both sets of brackets to the chassis. (Refer to Figure 3-4.) In the second configuration, two screws secure each rack-mount bracket to the chassis, and two additional screws secure each cable-management bracket to a rack-mount bracket. (Refer to Figure 3-5.) Figure 3-4 Rack-Mounting the Chassis in a Telco-Type Rack with Installed Cable-Management Brackets-Front Installation Shown EN TD TC RD RC LB CD TD TC RD RC LB CD TD TC RD RC LB CD TD TC RD RC LB CD ENABLED 0 5 3 1 Cisco 7200 Series ENABLED PCMCIA 1 2 3 0 1 LINK 2 3 ETHERNET 10BT FAST SERIAL ENABLED 0 MII 1 LINK RJ45 2 RX 3 TX TOKEN RING 6 FAST ETHERNET 4 ETHERNET-10BFL 2 RX 0 TX RX TX TX RX EN RX 0 TX 4 3 2 1 SLOT 1 FE MII RJ-45 RESET CPU FAST ETHERNET INPUT/OUTPUT CONTROLLER 0 EJECT SLOT 0 II MEN RJE4N5 RJL4IN5K R 1O POWK Rack-mount bracket Cable-management bracket H9453 Cisco 7206 Installation and Configuration Guide 3-4 OL-5102-02