Cisco 7206VXR Installation Guide - Page 89
Connecting DC-Input Power
UPC - 746320975061
View all Cisco 7206VXR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
Chapter 3 Installing the Cisco 7206 Connecting Power Step 3 Secure the cable in the power supply AC receptacle by sliding the cable-retention clip down until it fits around the connector. The cable-retention clip provides strain relief for the AC power cable (refer to Figure 3-21). Note For additional AC power cable strain relief, secure the cable to the power supply handle by inserting a nylon cable tie through the hole in the handle and around the cable. Warning The AC power supply for the Cisco 7206 has double pole/neutral fusing. Figure 3-21 Connecting AC-Input Power H6848 Power switch PWR OK LED Cable-retention AC power cable clip Hole for nylon cable tie Step 4 Plug the AC power supply cable into the AC power source. Step 5 Repeat Step 1 through Step 4 for the second power supply (if present). This completes the procedure for connecting AC-input power. Connecting DC-Input Power Connect a 280W DC-input power supply as follows: Note The color coding of the DC-input power supply leads depends on the color coding of the DC power source at your site. Typically, green or green/yellow is used for ground. Make certain the lead color coding you choose for the DC-input power supply matches lead color coding used at the DC power source. OL-5102-02 Cisco 7206 Installation and Configuration Guide 3-21