Cisco CISCO876-SEC-I-K9 Configuration Guide - Page 129

Chapter 13 Configuring Dial Backup and Remote Management Configuring Dial Backup and Remote Management Through the Console or Auxiliary Port Step 3 Command exit Purpose Enters global configuration mode. Example: Router(config-dhcp)# exit Router(config)# Step 4 chat-script script-name expect-send Example: Router(config)# chat-script Dialout ABORT ERROR ABORT BUSY "" "AT" OK "ATDT 5555102 T" TIMEOUT 45 CONNECT \c Router(config)# Configures a chat script used in dial-on-demand routing (DDR) to give commands to dial a modem and to log in to remote systems. The defined script is used to place a call over a modem. Step 5 interface type number Example: Router(config)# interface Async 1 Router(config-if)# Step 6 exit Creates and enters configuration mode for the asynchronous interface. • Configure the asynchronous interface. For sample commands you can use in async interface configuration mode, see the "Configuration Example" section on page 13-13. Enters global configuration mode. Example: Router(config-if)# exit Router(config)# Step 7 interface type number Enters interface configuration mode. Example: Router(config)# interface Dialer 3 Router(config-if)# Step 8 dialer watch-group group-number Specifies the group number for watch list. Example: Router(config-if)# dialer watch-group 1 Router(config-if)# Step 9 exit Enters global configuration mode. Example: Router(config-if)# exit Router(config)# OL-5332-01 Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide 13-11