Cisco CISCO876-SEC-I-K9 Configuration Guide - Page 159
Access Method, Prompt, Exit and Entrance Method, About This Mode, logout, enable, disable, con
UPC - 882658021800
View all Cisco CISCO876-SEC-I-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 159 highlights
Appendix A Cisco IOS Software Basic Skills Understanding Command Modes Table A-2 Command Modes Summary Mode User EXEC Access Method Begin a session with your router. Prompt Router> Privileged EXEC Enter the enable command from user EXEC mode. Router# Global configuration Enter the configure command from privileged EXEC mode. Router (config)# Interface configuration Enter the interface command (with a specific interface, such as interface atm 0) from global configuration mode. Router (config-if)# Exit and Entrance Method About This Mode To exit a router session, enter Use this mode for these tasks: the logout command. • Change terminal settings. • Perform basic tests. • Display system information. • To exit to user EXEC Use this mode for these tasks: mode, enter the disable • Configure your router command. operating parameters. • To enter global configuration mode, enter the configure • Perform the verification steps shown in this guide. command. To prevent unauthorized changes to your router configuration, access to this mode should be protected with a password as described in "Enable Secret Passwords and Enable Passwords" later in this chapter. • To exit to privileged Use this mode to configure EXEC mode, enter the parameters that apply to your exit or end command, or router as a whole. press Ctrl-Z. Also, you can access the following • To enter interface modes, which are described later in configuration mode, this table: enter the interface command. • Interface configuration • Router configuration • Line configuration • To exit to global Use this mode to configure configuration mode, parameters for the router Ethernet enter the exit command. and serial interfaces or • To exit to privileged subinterfaces. EXEC mode, enter the end command, or press Ctrl-Z. • To enter subinterface configuration mode, specify a subinterface with the interface command. OL-5332-01 Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide A-3