Cisco CISCO876-SEC-I-K9 Configuration Guide - Page 95
Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide, OL-5332-01
UPC - 882658021800
View all Cisco CISCO876-SEC-I-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
Chapter 8 Configuring a Simple Firewall Configuration Example Configuration Example A telecommuter is granted secure access to a corporate network, using IPSec tunneling. Security to the home network is accomplished through firewall inspection. The protocols that are allowed are all TCP, UDP, RTSP, H.323, NetShow, FTP, and SQLNet. There are no servers on the home network; therefore, no traffic is allowed that is initiated from outside. IPSec tunneling secures the connection from the home LAN to the corporate network. Like the Internet Firewall Policy, HTTP need not be specified because Java blocking is not necessary. Specifying TCP inspection allows for single-channel protocols such as Telnet and HTTP. UDP is specified for DNS. The following configuration example shows a portion of the configuration file for the simple firewall scenario described in the preceding sections. ! ! Firewall inspection is set up for all TCP and UDP traffic as well as ! specific application protocols as defined by the security policy. ip inspect name firewall tcp ip inspect name firewall udp ip inspect name firewall rtsp ip inspect name firewall h323 ip inspect name firewall netshow ip inspect name firewall ftp ip inspect name firewall sqlnet ! interface vlan 1! This is the internal home network. ip inspect firewall in ! Inspection examines outbound traffic. no cdp enable ! interface fastethernet 4! FE4 is the outside or Internet-exposed interface. ! acl 103 permits IPSec traffic from the corp. router ! as well as denies Internet-initiated traffic inbound. ip access-group 103 in ip nat outside no cdp enable ! ! acl 103 defines traffic allowed from the peer for the IPSec tunnel. access-list 103 permit udp host 200.1.1.1 any eq isakmp access-list 103 permit udp host 200.1.1.1 eq isakmp any access-list 103 permit esp host 200.1.1.1 any ! Allow ICMP for debugging but should be disabled because of security implications. access-list 103 permit icmp any any access-list 103 deny ip any any ! Prevents Internet-initiated traffic inbound. ! acl 105 matches addresses for the ipsec tunnel to or from the corporate network. access-list 105 permit ip 10.1.1.0 0.0.0.255 192.168.0.0 0.0.255.255 no cdp run ! OL-5332-01 Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide 8-5