Cisco CISCO876-SEC-I-K9 Configuration Guide - Page 45
Verifying Your Configuration
UPC - 882658021800
View all Cisco CISCO876-SEC-I-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Chapter 3 Configuring PPP over Ethernet with NAT Configuration Example Verifying Your Configuration Use the show ip nat statistics command in privileged EXEC mode to verify the PPPoE with NAT configuration. You should see verification output similar to the following example: Router# show ip nat statistics Total active translations: 0 (0 static, 0 dynamic; 0 extended) Outside interfaces: FastEthernet4 Inside interfaces: Vlan1 Hits: 0 Misses: 0 CEF Translated packets: 0, CEF Punted packets: 0 Expired translations: 0 Dynamic mappings: -- Inside Source [Id: 1] access-list 1 interface Dialer0 refcount 0 Queued Packets: 0 OL-5332-01 Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide 3-9
3-9
Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide
OL-5332-01
Chapter 3
Configuring PPP over Ethernet with NAT
Configuration Example
Verifying Your Configuration
Use the
show ip nat statistics
command in privileged EXEC mode to verify the PPPoE with NAT
configuration. You should see verification output similar to the following example:
Router#
show ip nat statistics
Total active translations: 0 (0 static, 0 dynamic; 0 extended)
Outside interfaces:
FastEthernet4
Inside interfaces:
Vlan1
Hits: 0
Misses: 0
CEF Translated packets: 0, CEF Punted packets: 0
Expired translations: 0
Dynamic mappings:
-- Inside Source
[Id: 1] access-list 1 interface Dialer0 refcount 0
Queued Packets: 0