Cisco CISCO876-SEC-I-K9 Configuration Guide - Page 23

Chapter 1 Basic Router Configuration Configuring Basic Parameters Configure the ATM WAN Interface This procedure applies only to the Cisco 857, Cisco 876, Cisco 877 and Cisco 878 models. Perform these steps to configure the ATM interface, beginning in global configuration mode: Step 1 Command For the Cisco 878 model only: controller dsl 0 mode atm exit Purpose For routers using the G.SHDSL signaling, perform these commands. Ignore this step for routers using ADSL signaling. Example: Router(config)# controller dsl 0 Router(config-controller)# mode atm Router(config-controller)# exit Router(config)# Step 2 interface type number Example: Router(config)# interface atm0 Router(config-int)# Identifies and enters the configuration mode for an ATM interface. Step 3 ip address ip-address mask Example: Router(config-int)# ip address 10.10.10.100 255.255.255.0 Router(config-int)# Sets the IP address and subnet mask for the ATM interface. Step 4 no shutdown Enables the ATM 0 interface. Example: Router(config-int)# no shutdown Router(config-int)# Step 5 exit Example: Router(config-int)# exit Router(config)# Exits configuration mode for the ATM interface and returns to global configuration mode. Configure the Wireless Interface The wireless interface enables connection to the router through a wireless LAN connection. For more information about configuring a wireless connection, see Chapter 9, "Configuring a Wireless LAN Connection," and the Cisco Access Router Wireless Configuration Guide. OL-5332-01 Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide 1-7