Cisco CISCO876-SEC-I-K9 Configuration Guide - Page 77

Chapter 6 Configuring a VPN Using Easy VPN and an IPSec Tunnel Verifying Your Easy VPN Configuration Step 5 Command or Action exit Purpose Returns to global configuration mode. Example: Router(config-crypto-ezvpn)# exit Router(config)# Step 6 Step 7 interface type number Example: Router(config)# interface fastethernet 4 Router(config-if)# Enters the interface configuration mode for the interface to which you want the Cisco Easy VPN remote configuration applied. Note For routers with an ATM WAN interface, this command would be interface atm 0. crypto ipsec client ezvpn name [outside | inside] Example: Router(config-if)# crypto ipsec client ezvpn ezvpnclient outside Router(config-if)# Assigns the Cisco Easy VPN remote configuration to the WAN interface, causing the router to automatically create the NAT or port address translation (PAT) and access list configuration needed for the VPN connection. Step 8 exit Returns to global configuration mode. Example: Router(config-crypto-ezvpn)# exit Router(config)# Verifying Your Easy VPN Configuration Router# show crypto ipsec client ezvpn Tunnel name :ezvpnclient Inside interface list:vlan 1 Outside interface:fastethernet 4 Current State:IPSEC_ACTIVE Last Event:SOCKET_UP Address:8.0.0.5 Mask:255.255.255.255 Default Domain:cisco.com Configuration Example The following configuration example shows a portion of the configuration file for the VPN and IPSec tunnel described in this chapter. ! aaa new-model ! aaa authentication login rtr-remote local aaa authorization network rtr-remote local aaa session-id common OL-5332-01 Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide 6-11