Cisco CP-7975G Administration Guide - Page 137

Chapter 5 Configuring Features, Templates, Services, and Users Telephony Features Available for the Phone Table 5-1 Telephony Features for the Cisco Unified IP Phone (continued) Feature Description Configuration Reference Intercom Allows users to place and receive intercom calls using programmable phone buttons. You can configure intercom line buttons to: For more information, refer to the Cisco Unified Communications Manager Feature and Services Guide, Intercom. • Directly dial a specific intercom extension. • Initiate an intercom call and then prompt the user to enter a valid intercom number. Note If your user logs into the same phone on a daily basis using their Cisco Extension Mobility profile, assign the phone button template that contains intercom information to their profile, and assign the phone as the default intercom device for the intercom line. Join/Select Creates a conference by joining together existing For more information, refer to the Cisco calls that are on a single phone line. Unified IP Phone Guide, Basic Call Handling chapter, Making Conference Calls section. Join Across Lines/Select Allows users to apply the Join feature to calls that For more information, refer to: are on multiple phone lines. • See Configuring Softkey Templates, page 5-27. • Refer to Cisco Unified Communications Manager System Guide, Cisco Unified IP Phones. Line select If this feature is disabled (default), then the ringing line is selected. When enabled, the primary line is picked up even if a call is ringing on another line. The User must manually select the other line. For more information, refer to the option "Always use prime line" in the following chapters of Cisco Unified Communications Manager Administration Guide: Note This feature can also be enabled or disabled • Device Profile Configuration for Extension Mobility. • Common Phone Profile Configuration • Cisco Unified IP Phone Configuration Line select for voice messages When disabled (default), pressing the Messages button selects the line that has a voice message. If more than one line has voice mail, then the first available line is selected. When enabled, the primary line is always used to retrieve voice messages. Note This feature can also be enabled or disabled for Extension Mobility. For more information, refer to the option Always use prime line for voice message in the following chapters of Cisco Unified Communications Manager Administration Guide: • Device Profile Configuration • Common Phone Profile Configuration • Cisco Unified IP Phone Configuration OL-23092-01 Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.5 5-13