Cisco CP-7975G Administration Guide - Page 97
SIP Configuration Menu for SIP Phones, SIP General Configuration Menu
View all Cisco CP-7975G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Chapter 4 Configuring Settings on the Cisco Unified IP Phone Device Configuration Menu SIP Configuration Menu for SIP Phones The SIP Configuration menu is available on SIP phones. This menu contains these sub-menus: • SIP General Configuration Menu, page 4-19 • Line Settings Menu for SIP Phones, page 4-20 SIP General Configuration Menu The SIP General Configuration menu displays information about the configurable SIP parameters on a SIP phone. Table 4-8 describes the options in this menu. Table 4-8 SIP General Configuration Menu Options Option Preferred CODEC Out of Band DTMF Register with Proxy Register Expires Phone Label Enable VAD Start Media Port End Media Port NAT Enabled NAT Address Call Statistics Description To Change Displays the CODEC to use when a call is Display only-cannot configure. initiated. This value will always be set to none. Displays the configuration of the out-of-band Display only-cannot configure. signaling (for tone detection on the IP side of a gateway). The Cisco Unified IP Phone (SIP) supports out-of-band signaling by using the AVT tone method. This value will always be set to avt. This value will always be set to Yes. Display only-cannot configure. Displays the amount of time, in seconds, after which a registration request expires. From Cisco Unified Communications Manager Administration, choose Device > Device Settings > SIP Profile. Displays the text that is displayed on the top right status line of the LCD on the phone. This text is for end-user display only and has no effect on caller identification or messaging. This value will always be set to null. Display only-cannot configure. This value is set to No by default. From Cisco Unified Communications Manager Administration, choose Device > Device Settings > SIP Profile. Displays the start Real-Time Transport Protocol From Cisco Unified Communications Manager (RTP) range for media. Administration, choose Device > Device Settings > SIP Profile. Displays the end Real-Time Transport Protocol From Cisco Unified Communications Manager (RTP) range for media. Administration, choose Device > Device Settings > SIP Profile. Displays if Network Address Translation (NAT) Display only-cannot configure. is enabled. This value will always be set to false. Displays the WAN IP address of the NAT or Display only-cannot configure. firewall server. This value will always be set to null. This value is set to No by default. From Cisco Unified Communications Manager Administration, choose Device > Device Settings > SIP Profile. OL-23092-01 Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.5 4-19