Compaq ProLiant 800 ProLiant 800 Servers Supporting Pentium II Processors and - Page 104

Index-3 diagnostic tools Continued ROMPaq 1-10 Diagnostics 1-10 Diagnostics (DIAGS) 2-10 DIAGS See Diagnostics DIMMs 1-2. See also memory accessing expansion sockets 3-1 installation alignment 3-14 installing 3-14 Slots (1-4) , system board 3-25 socket latches 3-15 disable floppy switch 3-24 disable password switch 3-24 disable video switch 3-24 disconnecting power 2-6 disk controllers 1-3 optional controller boards 1-3 SCSI, factory installed 1-3 SCSI, standard equipment 1-3 Wide-Ultra SCSI-3 1-3 diskette backplane connector 1-13 write control 1-10 diskette boot override 1-10 diskette drive control 1-10 installation 3-18 position 1-11 diskette drives 1-4 configuring with SmartStart 2-7 documentation 2-3 drive bays accessing 3-1 SCSI cabling 4-4 drive cage optional 1-4 drive cage positions 1-11 drives See hard drives or diskette drives Dual Inline Memory Modules (DRAM) 3-14 E ECC See Error Checking and Correcting electrostatic discharge 3-2, B-1 environment, site selection 2-2 Error Checking and Correcting memory 1-2 Ethernet connector 1-12, 2-6 event list, IML 5-4 expansion board inserting 3-13 securing 3-13 expansion boards accessing 3-1 configuring PCI with SmartStart 2-7 expansion I/O board cage labels 3-5 installing 2-4 ISA, installing 2-1 slot types 3-11 slots locations 3-11 expansion slots 1-3, 3-11 connectors 1-12, 2-6 installing an board 3-12 ISA 3-11 PCI 3-11 PCI bus speed 1-3 shared 3-11 Expansion System Board accessing 3-1 backplane connector 1-13 switches, slots, and connectors 3-23 external SCSI connector 1-12, 2-6 ProLiant 800 Servers Supporting Pentium II Processors and 100-MHz System Bus Setup and Installation Guide