Compaq ProLiant 800 ProLiant 800 Servers Supporting Pentium II Processors and - Page 38

3-1 Chapter 3 Overview of Installing Hardware Options For complete hardware option installation instructions, refer to the installation documentation that came with the option kit. For an illustrated overview of installing many Compaq option upgrades, refer to the Hardware Installation and Configuration poster included in the shipping box, or to the installation labels located on the inside of the large access panel and on the small access panel. If you have any problems, contact your Authorized Compaq Reseller. The new server chassis facilitates the installation of hardware upgrades. Most hardware options are installed on the expansion system board, on the processor system board, and in the drive bay area. Use the following table to determine how to gain access to internal server components. Table 3-1 Gaining Access to Internal Components To Gain Access To: Back of drive bays Expansion I/O slots Expansion system board Front of media drive bays Internal SCSI cable Internal SCSI connector Memory (DIMM) Second Pentium II processor (CPU) Switches for processor components You Will Need To: Open the front bezel* and remove the large access panel Open the front bezel* and remove the small access panel Open the front bezel* and remove the small access panel Open the front bezel* Open the front bezel* and remove the large access panel Open the front bezel* and remove the large access panel Remove the processor cage** Remove the processor cage** Remove the processor cage** Compaq ProLiant 800 Servers Supporting Pentium II Processors and 100-MHz System Bus Setup and Installation Guide