D-Link DES-3010FA-TAA CLI Guide - Page 111
ip igmp snooping leave-time-out
UPC - 790069296505
View all D-Link DES-3010FA-TAA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
IGMP Snooping Commands ip igmp snooping leave-time-out The ip igmp snooping leave-time-out Interface Configuration (VLAN) mode command configures the leavetime-out. If an IGMP report for a multicast group was not received for a leave-time-out period after an IGMP Leave was received from a specific port, this port is deleted from the member list of that multicast group.To return to the default configuration, use the no form of this command. Syntax ip igmp snooping leave-time-out {time-out | immediate-leave} no ip igmp snooping leave-time-out Parameters • time-out - Specifies the leave-time-out in seconds for IGMP queries. (Range: 0-2147483647) • immediate-leave - Indicates that the port should be immediately removed from the members list after receiving IGMP Leave. Default Configuration The default leave-time-out configuration is 10 seconds. Command Mode Interface Configuration (VLAN) mode User Guidelines The leave timeout should be set greater than the maximum time that a host is allowed to respond to an IGMP query. Use immediate leave only where there is just one host connected to a port. Example The following example configures the host leave-time-out to 60 seconds. Console(config)# interface vlan 2 Console(config-if)# ip igmp snooping leave-time-out 60 Page 110