D-Link DES-3010FA-TAA CLI Guide - Page 232
spanning-tree link-type, point-to-point, shared, no spanning-tree spanning-tree link-type
UPC - 790069296505
View all D-Link DES-3010FA-TAA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 232 highlights
D-Link DES-3010FA/GA CLI Reference Guide spanning-tree link-type The spanning-tree link-type Interface Configuration mode command overrides the default link-type setting determined by the duplex mode of the port and enables Rapid Spanning Tree Protocol (RSTP) transitions to the forwarding state. To return to the default configuration, use the no form of this command. Syntax spanning-tree link-type {point-to-point | shared} no spanning-tree spanning-tree link-type Parameters • point-to-point -Indicates that the port link type is point-to-point. • shared - Indicates that the port link type is shared. Default Configuration The device derives the port link type from the duplex mode. A full-duplex port is considered a point-to-point link and a half-duplex port is considered a shared link.. Command Modes Interface Configuration (Ethernet, port-channel) mode User Guidelines There are no user guidelines for this command. Example The following example enables shared spanning-tree on Ethernet port 5. Console(config)# interface ethernet 5 Console(config-if)# spanning-tree link-type shared Page 231