D-Link DES-3010FA-TAA CLI Guide - Page 95
port storm-control broadcast enable
UPC - 790069296505
View all D-Link DES-3010FA-TAA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
Ethernet Configuration Commands port storm-control broadcast enable The port storm-control broadcast enable Interface Configuration (Ethernet) mode command enables broadcast storm control. To disable broadcast storm control, use the no form of this command. Syntax port storm-control broadcast enable no port storm-control broadcast enable Default Configuration Broadcast storm control is disabled. Command Modes Interface Configuration (Ethernet) mode User Guidelines Use the port storm-control broadcast rate Interface Configuration (Ethernet) mode command, to set the maximum allowable broadcast rate. Use the port storm-control include-multicast Interface Configuration (Ethernet) mode command to enable counting multicast packets and optionally unknown unicast packets in the storm control calculation. The command can be enabled on a specific port only if rate-limit interface configuration command is not enabled on that port. Example The following example enables broadcast storm control on Ethernet port 5. Console(config)# interface ethernet 5 Console(config-if)# port storm-control broadcast enable Page 94