D-Link DES-3226 Reference Manual - Page 106
config stp ports
UPC - 790069240560
View all D-Link DES-3226 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
DES-3226S Layer 2 Fast Ethernet Switch User's Guide config stp ports Purpose Used to setup STP on the port level. Syntax config stp ports {cost /priority /state [enabled/disabled] Description This command is used to create and configure STP for a group of ports. Parameters cost − this defines a metric that indicates the relative cost of forwarding packets to the specified port list. The default cost for a 1000 Mbps port is 4, a 100 Mbps port is 19, and for a 10 Mbps port the default cost is 100. priority − a numeric value between 0 and 31 that is used in determing the root and designated port in an STP port list. The default is 16, with 0 indicating the highest priority. − specifies a range of ports to be configured. The port list is specified by listing the lowest switch number and the beginning port number on that switch, separated by a colon. Then highest switch number, and the highest port number of the range (also separeted by a colon) are specified. The beginning and end of the port list range are seperated by a dash. For example, 1:3 would specify switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and 106 Spanning Tree Commands