D-Link DES-3226 Reference Manual - Page 174

DES-3226S Layer 2 Fast Ethernet Switch User's Guide config gvrp Purpose Syntax Description Parameters Used to configure GVRP on the switch. config gvrp [/all] {state [enabled/disabled]/ingress_checking [enabled/disabled]/pvid } This command is used to configure the Group VLAN Registration Protocol on the switch. You can configure ingress checking, the sending and receiving of GVRP information, and the Port VLAN ID (PVID). − A range of ports for which you want ingress checking. The port list is specified by listing the lowest switch number and the beginning port number on that switch, separated by a colon. Then highest switch number, and the highest port number of the range (also separeted by a colon) are specified. The beginning and end of the port list range are seperated by a dash. For example, 1:3 would specify switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and switch 2, port 4 − in numerical order. all − Specifies all of the ports on the switch. state [enabled/disabled] − Enabled or disables GVRP for the ports specified in the port list. ingress_checking [enabled/disabled] − Enables or disables ingress checking for the specified 174 VLAN Commands