Dell 2155cn User Manual - Page 271

FILE LOCATION: C:\Users\fxstdpcadmin\Desktop\0630_UG??\Mioga_AIO_UG_FM\Mioga_AIO_UG_FM\section14.fm NOTICE: Before buying large quantities of any print media, it is recommended that you try a sample first. When printing on labels: • Use labels that can withstand temperatures of 205 °C (401 °F) without sealing, excessive curling, wrinkling, or releasing hazardous emissions. • Set the paper type to Label from the printer driver. • Use "Standard Tray" for label. • Do not print through "Single Sheet Feeder" for label. • Do not load labels together with paper in the same tray. • Do not print within 1 mm (0.04 inches) of the die-cut. • Do not print within 1 mm (0.04 inches) of the edge of the label, of the perforations, or between die-cuts of the label. • Do not print a label through the printer more than once. • Portrait orientation is preferred, especially when printing bar codes. • Do not use labels that have exposed adhesive. • Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a jam. • Do not use label sheets that have adhesive to the edge of the sheet. It is recommended that zone coating of the adhesive is done at least 1 mm (0.04 inches) away from edges. Adhesive material contaminates your printer and could void your warranty. CAUTION: Otherwise the printer occur in a jam and contaminate your printer and your cartridges with adhesive. As a result, could void your printer and cartridge warranties. Storing Print Media For proper print media storage, the following guidelines will help to avoid media feeding problems and uneven print quality. • Store print media in an environment where the temperature is approximately 21 °C (70 °F) and the relative humidity is 40 %. • Store cartons of print media on a pallet or shelf, rather than directly on the floor. D E L L C ON F I D E N T I A L - P R E L I M I N A RY 9 / 1 3 / 1 0 - F O R P R O O F O N LY Print Media Guidelines 269