Dell Force10 S25-01-GE-24T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 1026

www.dell.com | support.dell.com ip ospf priority c e s Set the priority of the interface to determine the Designated Router for the OSPF network. Syntax ip ospf priority number To return to the default setting, enter no ip ospf priority. Parameters number Enter a number as the priority. Range: 0 to 255. The default is 1. Defaults 1 Command Modes INTERFACE Command History Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage Information Setting a priority of 0 makes the router ineligible for election as a Designated Router or Backup Designated Router. Use this command for interfaces connected to multi-access networks, not point-to-point networks. ip ospf retransmit-interval c e s Set the retransmission time between lost link state advertisements (LSAs) for adjacencies belonging to the interface. Syntax ip ospf retransmit-interval seconds To return to the default values, enter no ip ospf retransmit-interval. Parameters seconds Enter the number of seconds as the interval between retransmission. Range: 1 to 3600. Default: 5 seconds. This interval must be greater than the expected round-trip time for a packet to travel between two routers. Defaults 5 seconds Command Modes INTERFACE Command History Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage Set the time interval to a number large enough to prevent unnecessary retransmissions. For example, Information the interval should be larger for interfaces connected to virtual links. 1026 | Open Shortest Path First (OSPFv2 and OSPFv3)