Dell Force10 S25-01-GE-24T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 723

show ipv6 cam linecard c e s Displays the IPv6 CAM entries for the specified line card. Syntax show ipv6 cam linecard slot-number port-set {0-1} [summary | index | ipv6 address] Parameters slot-number port-set summary index ipv6-address Enter the line card slot ID number. Range: 0 to 13 on the E1200; 0 on 6 for E600, and 0 to 5 on the E300. Enter the Port Set to (OPTIONAL) Enter the keyword summary to display a table listing network prefixes and the total number prefixes which can be entered into the IPv6 CAM. (OPTIONAL) Enter the index in the IPv6 CAM Enter the IPv6 address in the x:x:x:x::x/n format to display networks that have more specific prefixes. Range: /0 to /128 Note: The :: notation specifies successive hexadecimal fields of zeros. Defaults No default values or behavior Command Modes EXEC EXEC Privilege Command History Version 8.4.2.1 Version 8.2.1.0 Version 7.8.1.0 Version 7.4.1.0 Introduced on S-Series Introduced on E-Series ExaScale Introduced on C-Series Introduced on E-Series TeraScale Usage Information The forwarding table displays host route first, then displays route originated by routing protocol including static route. The egress port section displays the egress port of the forwarding entry which is designated as: C for the Control Processor 1 for the Route Processor 1 2 for the Route Processor 2 Note: If a link-local IPv6 address is statically configured and dynamically learned on a C-Series router, the dynamically -learned IPv6 address is displayed in show ipv6 cam linecard output, but the statically-configured IPv6 address may not be displayed. Use the show ipv6 fib linecard or show ipv6 neighbors commands to display statically-configured addresses of IPv6 neighbors. IPv6 Basics | 723