Dell Force10 S25-01-GE-24T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 870

www.dell.com | support.dell.com Parameters mac-address output interface vlan vlan-id Defaults Not configured. Command Modes CONFIGURATION Command History Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Related Commands show mac-address-table Enter the 48-bit hexidecimal address in nn:nn:nn:nn:nn:nn format. Enter the keyword output followed by one of the following interfaces: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a SONET interface, enter the keyword sonet followed by the slot/ port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. Enter the keyword vlan followed by a VLAN ID. Range:1 to 4094. Introduced on S-Series Introduced on C-Series Introduced on E-Series Displays the MAC address table. mac-address-table station-move threshold c e Change the frequency with which the MAC address station-move trap is sent after a MAC address changes in a VLAN. A trap is sent if a station move is detected above a threshold number of times in a given interval. Syntax [no] mac-address-table station-move threshold number interval count Parameters threshold number interval seconds Enter the keyword threshold followed by the number of times MAC addresses in VLANs can change before an SNMP trap is sent. Range: 1 to 10 Enter the keyword interval followed by the number of seconds. Range: 5 to 60 Defaults Not configured. Command Modes CONFIGURATION Command History Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on C-Series Introduced on E-Series 870 | Layer 2