Dell Force10 S25-01-GE-24T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 209
ip access-group
View all Dell Force10 S25-01-GE-24T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 209 highlights
ip access-group c e s Assign an IP access list (IP ACL) to an interface. Syntax ip access-group access-list-name {in | out} [implicit-permit] [vlan vlan-id] Parameters access-list-name in out implicit-permit vlan vlan-id Enter the name of a configured access list, up to 140 characters. Enter the keyword in to apply the ACL to incoming traffic. Enter the keyword out to apply the ACL to outgoing traffic. Note: Available only on 12-port 1-Gigabit Ethernet FLEX line card. Refer to your line card documentation for specifications. Not available on S-Series. (OPTIONAL) Enter the keyword implicit-permit to change the default action of the ACL from implicit-deny to implicit-permit (that is, if the traffic does not match the filters in the ACL, the traffic is permitted instead of dropped). (OPTIONAL) Enter the keyword vlan followed by the ID numbers of the VLANs. Range: 1 to 4094, 1-2094 for ExaScale (can used IDs 1-4094) Defaults Not enabled. Command Modes INTERFACE Command History Version 8.1.1.0 Version 7.8.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on E-Series ExaScale Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16 characters long. Support added for S-Series Support added for C-Series Introduced Usage Information You can assign one ACL (standard or extended ACL) to an interface. Note: This command is supported on the loopback interfaces of EE3, and EF series RPMs. It is not supported on loopback interfaces ED series RPM, or on C-Series or S-Series loopback interfaces. Related Commands When you apply an ACL that filters IGMP traffic, all IGMP traffic is redirected to the CPUs and soft-forwarded, if required, in the following scenarios: • on a Layer 2 interface - if a Layer 3 ACL is applied to the interface. • on a Layer 3 port or on a Layer 2/Layer 3 port ip access-list standard ip access-list extended Configure a standard ACL. Configure an extended ACL. Access Control Lists (ACL) | 209